hostlasvegas.blogg.se

1. THUNDERBOLT ADD IN CARD NO HEADER STARTECH INSTALL
2. THUNDERBOLT ADD IN CARD NO HEADER STARTECH DRIVERS

Even if your board for some strange reason have a thunderbolt header I would not use it.

THUNDERBOLT ADD IN CARD NO HEADER STARTECH INSTALL

Also remember to enable thunderbolt and no security after a bios update.Īfter all this install the latest thunderbolt driver from Gigabyte support: 17.2.71.250īy the way there is no thunderbolt header on that motherboard so you can ONLY use the native thunderbolt port back on the motherboard. You should probably install the latest bios and chipset before you use the FW update tool. Thunderbolt function will be available after system powers on.Īlso updated to the latest bios and the latest chipset drivers. Remove the system power cord for at least 30 seconds after FW update. If you have tried that FW update tool try it again. You probably have to uninstall the thunderbolt driver and audio interface driver first. You did install the Thunderbolt FW Update Tool? It can be found here:įollow the instructions very closely. I might try and get a apple thunderbolt cable (and spend another 50 bucks mehhh)Īlso this weekend i'll take my Q2626 to a friend who has a Macbook with TB3 to try and see if the Q2626 is working. What worries me is that i've read some examples where people tell that their Quantum device sync light starts blinking red even when they just boot their PC (before the OS is loaded so I think this has nothing to do with Universal Control?) It would be nice if someone from Presonus support could enlighten me on this or someone else who has a Q2626. Whenever I set the Security Level settings in BIOS to anything other than 'none' the thunderbolt software shows Controller driver version 'Unknown' so I figured that's not the way to go. Tried the Gigabyte Intel ME Critical update but the setup utility tells me there's no need because it's already patched. Gigabyte have a rev1 card and a rev 2 card - I mostly have rev 1 cards but do have a rev 2 card - but check the pages below for compatibilityĪlso i've installed the USB3.1 driver (15.2.30.250) There are several versions of the thunderbolt driver available dating back to 2015 - 2014 or what ever. Mess around and try booting with the Quantum switched on - and vice versa boot the machine and switch on quantum after booting - a combination may be needed. There may be a force power to thunderbolt option in the BIOS.

THUNDERBOLT ADD IN CARD NO HEADER STARTECH DRIVERS

Make sure the BIOS has thunderbolt enabled - make sure the card is inserted into the correct PCI-e slot - make sure the other USB drivers including ASMEDIA 3 drivers are installed correctly if your board had ASMEDIA USB as well. I've installed thunderbolt on several motherboards - and it can be a pain in the neck.